Kontron NSC2U IP Network Server Instrukcja Użytkownika Strona 116

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 115
NSC2U Server—5
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4 December 2009
116
3. Connect the five power supply harness connectors on the server board and the SFP
board.
4. Replace the drive bay assembly.
5. Replace the PCI riser card assembly.
6. Replace the PCI fan assembly and the CPU fan assembly and processor air duct.
7. If this is the last task you are performing, replace the top cover of the chassis.
Reconnect all the external devices and plug in the power cord(s).
For information about mounting the server in a rack, see Section 3.5, “Installing
the Server into a Rack” on page 48.
5.6 Replacing the Server Board
The IP Network Server NSC2U uses the Intel
®
Server Board T5000PAL. To replace the
server board, the following components must be removed:
Processor air duct
CPU fan assembly
PCI riser assembly and add-in cards
Any I/O expansion module or RMM module
Cables connected to the board and the bridge board
The HDD drive bay assembly
In addition, you may want to remove the following components on the board to re-use
them on the replacement board if it isn’t already populated:
•Heat sink(s)
Processor(s)
Figure 102. Installing the PDB
TS000569
A
B
Przeglądanie stron 115
1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 151 152

Komentarze do niniejszej Instrukcji

Brak uwag