Kontron NSC2U IP Network Server Instrukcja Użytkownika Pobierz pdf (Strona 112)

NSC2U Server—5

Kontron IP Network Server NSC2U

Product Guide, rev. 1.4 December 2009

112

5.4.2 Removing the SAS Backplane Board from the Drive Bay

Assembly

If you need to replace the SAS Backplane Board or use it on another drive bay

assembly, follow these steps:

1. Detach all drives or filler blanks attached to the backplane board. For instructions,

see Section 3.3.1 and Section 4.9.1

2. Loosen the three screws that fasten the backplane board to the drive bay assembly.

(Figure 98, “A”)

3. Pull the backplane board off of the rear of the drive bay assembly

5.4.3 Installing a New SAS Backplane Board

To install a new backplane board, the drive bay assembly must be removed from the

chassis and the old backplane board removed first. See the procedures above in

Section 5.4.1 and Section 5.4.2.

1. Line up the new backplane board with the back of the drive bay assembly.

(Figure 99 “A”)

2. Fasten the backplane board to the drive bay assembly with three screws, as shown.

(“B”)

Figure 98. Removing the SAS Backplane Board

TS000315

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 151 152

Brak uwag

Kontron NSC2U IP Network Server Instrukcja Użytkownika Strona 112