Kontron pITX-E38 Instrukcja Użytkownika Pobierz pdf (Strona 8)

KTD-N0904-D Page 6 Installation Procedure

pITX-E38 Users Guide

Warning: Turn off PSU (Power Supply Unit) completely (no mains power connected to the PSU) or

leave the Power Connectors unconnected while configuring the board. Otherwise components

(RAM, LAN cards etc.) might get damaged. Make sure to use +5V single supply only. Alternatively

use a standard ATX PSU with suitable cable kit and PS_ON# active.

2 Installation Procedure

Installing the Board 2.1

To get the board running follow these steps. If the board shipped from KONTRON has already components

like RAM and CPU cooler mounted, then relevant steps below can be skipped.

1. Turn off the PSU (Power Supply Unit)

2. Insert the DDR3L SODIMM module

For a list of approved DDR3L SODIMMs contact your Distributor or FAE. See also chapter “System Memory

Support”.

3. Cooler Installation

Normally the cooler is premounted, but in case not, then make sure the heat paste etc. on the cooler is

intact and cover the full area of the SoC. Connect Cooler Fan electrically to the FAN_CPU connector.

4. Connecting Interfaces

Insert all external cables for hard disk, keyboard etc. A monitor must be connected in order to change

BIOS settings.

5. Connect and turn on PSU

Connect PSU to the board by the +5Vin-Internal connector or the +5Vin-External connector. Please note

that current limitations apply, see relevant connector description.

6. Power Button

If the board does not start by itself when switching on the ATX PSU AC mains, then follow these

instructions to start the board. Install the Always On Jumper in the Always On position or toggle the

PWRBTN_IN# signal (available in the FRONTPNL connector), by momentary shorting pins 2 (PWRBTN_IN#)

and pin 4 (GND). A “normally open” switch is recommended.

7. BIOS Setup

Enter the BIOS setup by pressing the <F2> key during boot up.

Enter “Exit Menu” and Load Setup Defaults.

Refer to the “BIOS Configuration / Setup“ section of this manual for details on BIOS setup. Please note

that BIOS may boot in UEFI shell, if so then type exit to activate BIOS menu and select Set-up.

Note: To clear all BIOS settings, including Password protection, activate “Clear CMOS Settings” Jumper

for ⋲10 sec (without power connected).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 60 61

Brak uwag

Kontron pITX-E38 Instrukcja Użytkownika Strona 8