Kontron KTLX800-pITX Instrukcja Użytkownika Pobierz pdf (Strona 33)

KTD-S0022-C Page 28 Digital I/O Interface

KTLX800/pITX User's Guide

The digital I/O interface is available through the Molex connector J2 (10 pins). An interface cable (open

is O-PROTO-10, part number 62038). ended) deliverable from KONTRON (KAB-GPI

Header Pin Signal Name Function

VCC

Power +3.3V

GPIO4 2 Bidirectional I/O 4

3 GPIO0 Bidirectional I/O 0

4 GPIO5 Bidirectional I/O 5

5 GPIO1 Bidirectional I/O 1

6 GPIO6 Bidirectional I/O 6

7 GPIO2 Bidirectional I/O 2

8 GPIO7 Bidirectional I/O 7

9 GPIO3 Bidirectional I/O 3

10 GND Ground

Note: 1) To protect the external power lines of peripheral devi ake sure that

- the wires have the right diameter to withstand the maximum available current.

- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.

ces m

13.5 Special I/O Modes

13.5.1 IRQ Mode

All edge of the signal.

However for th lines are used. If

more IRQ pins shou the input pins.

13.5.2 Tri-Sta

tri-state mode the pins are automatically configured as output pins. In contrast to a standard ouput pin

the tri-state pin can also be used as an input pin (i.e. acknowledge from I2C-Bus).

sixteen I/O lines can be configured to trigger an interrupt on the falling or rising

e interrupt handling only IRQ6 and IRQ7 are available even when more

ld be used the identification of the source must be done by sampling

te Mode

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 65 66

Brak uwag

Kontron KTLX800-pITX Instrukcja Użytkownika Strona 33