Kontron AT8902M CLI Instrukcja Użytkownika Strona 41
- Strona / 315
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
AT8902M Switching Commands
Page 2 - 5 AT8902M CLI Reference Manual
2.1.9 speed all
This command sets the speed and duplex setting for all interfaces.
Format
speed all {<100 | 10> <half-duplex | full-duplex>}
Mode Global Config
Acceptable values are:
100h 100BASE-T half-duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex
2.1.10 show port
This command displays port information.
Format
show port {<slot/port> | all}
Mode Privileged EXEC
Interface Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of port.
The possible values are:
Mirror - this port is a monitoring port. For more information, see 2.13
“Port Mirroring” on page 2 - 56.
PC Mbr- this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Admin Mode Selects the Port control administration state. The port must be enabled
in order for it to be allowed into the network. - May be enabled or dis-
abled. The factory default is enabled.
Physical Mode Selects the desired port speed and duplex mode. If auto-negotiation
support is selected, then the duplex mode and speed is set from the
auto-negotiation process. Note that the maximum capability of the port
(full duplex -100M) is advertised. Otherwise, this object determines
the port's duplex mode and transmission rate. The factory default is
Auto.
Physical Status Indicates the port speed and duplex mode.
Link Status Indicates whether the Link is up or down.
Link Trap This object determines whether or not to send a trap when link status
changes. The factory default is enabled.
LACP Mode Displays whether LACP is enabled or disabled on this port.
2.1.11 show port protocol
This command displays the Protocol-Based VLAN information for either the entire
system, or for the indicated group.
Format
show port protocol {<groupid> | all}
- AT8902M CLI Reference Manual 1
- AdvancedTCA 1
- AT8902M Preface 2
- Table of Contents 3
- Table of Contents AT8902M 10
- AT8902M Table of Contents 11
- Appendix 19
- Preface AT8902M 22
- 1.1 Command Syntax 28
- 1.2 Command Conventions 28
- 1.2.1 Common Parameter Values 29
- 1.5 Command Modes 31
- 1.5.2 CLI Error Messages 34
- 1.6 Using CLI Help 35
- 1.7 Accessing the CLI 36
- Switching Commands 37
- 2. Switching Commands 38
- Switching Commands AT8902M 100
- AT8902M Switching Commands 101
- Routing Commands 115
- Chapter 1 115
- 3. Routing Commands 116
- AT8902M Routing Commands 117
- Routing Commands AT8902M 118
- Quality of Service Commands 169
- 4.1.3 classofservice trust 171
- [<slot/port>] 174
- 4.2.1 diffserv 175
- 4.3 DiffServ Class Commands 176
- 4.3.2 class-map rename 177
- 4.3.3 match ethertype 177
- 4.3.4 match any 177
- 4.3.5 match class-map 177
- 4.3.5.1 no match class-map 178
- 4.3.6 match cos 178
- 4.3.7 match secondary-cos 178
- 4.3.9 match dstip 179
- 4.3.10 match dstl4port 179
- 4.3.11 match ip dscp 179
- 4.3.12 match ip precedence 179
- 4.3.13 match ip tos 180
- 4.3.14 match protocol 180
- 4.3.16 match srcip 181
- 4.3.17 match srcl4port 181
- 4.3.18 match vlan 181
- 4.4 DiffServ Policy Commands 182
- 4.4.2 drop 183
- 4.4.3 mirror 183
- 4.4.4 redirect 183
- 4.4.5 conform-color 183
- 4.4.6 class 183
- 4.4.6.1 no class 184
- 4.4.7 mark cos 184
- 4.4.8 mark ip-dscp 184
- 4.4.9 mark ip-precedence 184
- 4.4.10 police-simple 185
- 4.4.11 policy-map 185
- 4.4.11.1 no policy-map 185
- 4.5 DiffServ Service Commands 186
- 4.6 DiffServ Show Commands 187
- 4.6.2 show diffserv 188
- 4.6.3 show policy-map 188
- 4.6.4 show diffserv service 190
- 4.6.7 show service-policy 191
- 4.7.3 {deny 192
- 4.7.4 mac access-group 194
- 4.7.4.1 no mac access-group 194
- 4.7.5 show mac access-lists 194
- 4.8.1 access-list 195
- 4.8.1.1 no access-list 196
- 4.8.2 ip access-group 197
- 4.8.2.1 no ip access-group 197
- 4.8.3 acl-trapflags 197
- 4.8.3.1 no acl-trapflags 197
- 4.8.4 show ip access-lists 197
- 4.8.5 show access-lists 198
- 4.9 ACL trap commands 199
- Utility Commands 201
- 5. Utility Commands 202
- AT8902M Utility Commands 203
- Utility Commands AT8902M 204
- Management Commands 253
- 6. Management Commands 254
- AT8902M Management Commands 255
- Management Commands AT8902M 256
- Getting Help 289
- A. Getting Help 290
- AT8902M Getting Help 291
- Getting Help AT8902M 292
- (if not under warranty) 293
- List of Commands 295
- B. List of Commands 296
- AT8902M List of Commands 297
- List of Commands AT8902M 298
Powiązane produkty i podręczniki dla Sprzęt komputerowy Kontron AT8902M CLI
(93 strony)Rugged-ridge Windshield Auxiliary Light Mounting Brackets, 07-1 manuals
Owner’s manuals and user’s guides for For the car Rugged-ridge Windshield Auxiliary Light Mounting Brackets, 07-1.
We providing 1 pdf manuals Rugged-ridge Windshield Auxiliary Light Mounting Brackets, 07-1 for download free by document types: User Manual
Komentarze do niniejszej Instrukcji