Kontron AT8902M CLI Instrukcja Użytkownika Strona 130
- Strona / 315
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Routing Commands AT8902M
AT8902M CLI Reference Manual Page 3 - 16
3.3.6.1 no ip irdp preference
This command configures the default preferability of the address as a default router
address, relative to other router addresses on the same subnet.
Format
no ip irdp preference
Mode Interface Config
3.3.7 show ip irdp
This command displays the router discovery information for all interfaces, or a
specified interface.
Format
show ip irdp {<slot/port> | all}
Modes Privileged EXEC
User EXEC
Interface The <slot/port
> that matches the rest of the information in the row.
Ad Mode The advertise mode, which indicates whether router discovery is
enabled or disabled on this interface.
Advertise Address The IP address to which the interface sends the advertisement.
Max Int The maximum advertise interval, which is the maximum time, in sec-
onds, allowed between sending router advertisements from the inter-
face.
Min Int The minimum advertise interval, which is the minimum time, in sec-
onds, allowed between sending router advertisements from the inter-
face.
Hold Time The amount of time, in seconds, that a system should keep the router
advertisement before discarding it.
Preference The preference of the address as a default router address, relative to
other router addresses on the same subnet.
3.4 Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing
and to view VLAN routing status information.
3.4.1 vlan routing
This command creates routing on a VLAN. The <vlanid> value has a range from 1 to
4094.
Format
vlan routing <vlanid>
Mode VLAN Config
3.4.1.1 no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to
4094.
Format
no vlan routing <vlanid>
- AT8902M CLI Reference Manual 1
- AdvancedTCA 1
- AT8902M Preface 2
- Table of Contents 3
- Table of Contents AT8902M 10
- AT8902M Table of Contents 11
- Appendix 19
- Preface AT8902M 22
- 1.1 Command Syntax 28
- 1.2 Command Conventions 28
- 1.2.1 Common Parameter Values 29
- 1.5 Command Modes 31
- 1.5.2 CLI Error Messages 34
- 1.6 Using CLI Help 35
- 1.7 Accessing the CLI 36
- Switching Commands 37
- 2. Switching Commands 38
- Switching Commands AT8902M 100
- AT8902M Switching Commands 101
- Routing Commands 115
- Chapter 1 115
- 3. Routing Commands 116
- AT8902M Routing Commands 117
- Routing Commands AT8902M 118
- Quality of Service Commands 169
- 4.1.3 classofservice trust 171
- [<slot/port>] 174
- 4.2.1 diffserv 175
- 4.3 DiffServ Class Commands 176
- 4.3.2 class-map rename 177
- 4.3.3 match ethertype 177
- 4.3.4 match any 177
- 4.3.5 match class-map 177
- 4.3.5.1 no match class-map 178
- 4.3.6 match cos 178
- 4.3.7 match secondary-cos 178
- 4.3.9 match dstip 179
- 4.3.10 match dstl4port 179
- 4.3.11 match ip dscp 179
- 4.3.12 match ip precedence 179
- 4.3.13 match ip tos 180
- 4.3.14 match protocol 180
- 4.3.16 match srcip 181
- 4.3.17 match srcl4port 181
- 4.3.18 match vlan 181
- 4.4 DiffServ Policy Commands 182
- 4.4.2 drop 183
- 4.4.3 mirror 183
- 4.4.4 redirect 183
- 4.4.5 conform-color 183
- 4.4.6 class 183
- 4.4.6.1 no class 184
- 4.4.7 mark cos 184
- 4.4.8 mark ip-dscp 184
- 4.4.9 mark ip-precedence 184
- 4.4.10 police-simple 185
- 4.4.11 policy-map 185
- 4.4.11.1 no policy-map 185
- 4.5 DiffServ Service Commands 186
- 4.6 DiffServ Show Commands 187
- 4.6.2 show diffserv 188
- 4.6.3 show policy-map 188
- 4.6.4 show diffserv service 190
- 4.6.7 show service-policy 191
- 4.7.3 {deny 192
- 4.7.4 mac access-group 194
- 4.7.4.1 no mac access-group 194
- 4.7.5 show mac access-lists 194
- 4.8.1 access-list 195
- 4.8.1.1 no access-list 196
- 4.8.2 ip access-group 197
- 4.8.2.1 no ip access-group 197
- 4.8.3 acl-trapflags 197
- 4.8.3.1 no acl-trapflags 197
- 4.8.4 show ip access-lists 197
- 4.8.5 show access-lists 198
- 4.9 ACL trap commands 199
- Utility Commands 201
- 5. Utility Commands 202
- AT8902M Utility Commands 203
- Utility Commands AT8902M 204
- Management Commands 253
- 6. Management Commands 254
- AT8902M Management Commands 255
- Management Commands AT8902M 256
- Getting Help 289
- A. Getting Help 290
- AT8902M Getting Help 291
- Getting Help AT8902M 292
- (if not under warranty) 293
- List of Commands 295
- B. List of Commands 296
- AT8902M List of Commands 297
- List of Commands AT8902M 298
Powiązane produkty i podręczniki dla Sprzęt komputerowy Kontron AT8902M CLI
(93 strony)© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.045 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji