Kontron KBox C-101 Instrukcja Użytkownika Pobierz pdf (Strona 37)

10. Accessing Internal Components KBox C-101 – User’s Guide (Version 2.00)

10.2. Opening and Closing the KBox C-101

For opening and closing the KBox C-101, please perform the following steps:

Before opening the KBox C-101, the system must be switched off and disconnected from the main power

supply. Also, disconnect all peripheral devices from the KBox C-101. Before you begin, ensure that you

have a clean, flat and ESD-safe surface to work on.

1. Close all applications. Shut down the system properly and disconnect the connection to the power source.

Disconnect all peripherals.

2. The KBox C-101should lay on a flat, clean surface with the top side facing upwards.

3. Loosen the knurled screws, which secure the top cover on the front of the system (refer to

Fig. 10, pos. 3 and Fig. 30).

4. Pull the cover out a little bit, as shown in

Fig. 30, to release the cover centering and fixing brackets.

Fig. 30: This movment allow you to remove the centring and fixing bracket of the top cover (detail of the KBox C-101)

5. Lift the top cover up (on the front edge) and remove it (Fig. 31). Now you have access to the internal PCIe /Mini PCIe

and mSATA slots or cards respectively HDD/SSD in order to remove or install hardware components.

Fig. 31: Removing the cover (detail of the KBox C-101)

www.kontron.com 35

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 70 71

Brak uwag

Kontron KBox C-101 Instrukcja Użytkownika Strona 37