Kontron NetBootLoader Instrukcja Użytkownika Pobierz pdf (Strona 74)

ID 1022-8317, Rev. 2.0

Command Syntax NetBootLoader

Page 66

FUNCTION: Reset the system

SYNTAX:

DESCRIPTION: To permit the operator to force a restart of the system, the command

RS is used.

This command terminates the NetBootLoader command interpreter

and resets the entire system.

If this command is issued over a remote telnet connection, the telnet

session is terminated prior to the generation of the reset.

RUN (SMP)

FUNCTION: (Loads and) starts a bootable image

SYNTAX:

run [-c|<num>]

where:

run command

-c option: check

do not start the image if the “md5” check failed

<num> parameter: string

0, 1, 2, 3

ID number of the image to be booted

no other values than those above are supported

if no image is specified, the image in the data buffer

is booted

DESCRIPTION: This command is used to (load and) start a boot image.

If the image to be started is located in the NBL Flash, it is loaded to

the data buffer and then started.

If the image to be started is already located in the data buffer it is

started.

When used with the “-c” option, only a valid image is started. Refer to

the LOAD command for further information.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 85 86

Brak uwag

Kontron NetBootLoader Instrukcja Użytkownika Strona 74