Kontron M2M Smart Services Developer Kit User Manual Instrukcja Użytkownika Strona 1

b Kontron M2M Smart Services Developer Kit User Manual Document Revision 1.06 Kontron CG2100 Carrier Grade Server Document Revision 1.0

10 2.2 Kontron M2M System Panel Features Figure 5a. Kontron M2M System Overview Figure 5c. Kontron M2M System Label (Close-up of 2.25 in

11 Figure 5c. Kontron M2M System Top View Table 3 M2M system top and bottom view features Item Description Item Description A 3G/4G SIM s

12 Figure 6. Kontron M2M System Bottom View As shown in Figure 6, there are mounting holes at each of the corners of the brack

13 Table 4. M2M System side view features Item Description Item Description A USB 2.0 Host Port for Serial Redirection (selected SKUs only

14 Figure 8. M2M System AV End View Table 5. M2M System other side view features Item Description Item Description A Headphone/Line Out

15 Figure 9 shows the label side of the M2M System. Figure 9. M2M System label side view Table 6. M2M System front and back panel fea

16 2.3 Antennas There are 2 antennas for 802.11 (WLAN) and 802.15.4 (WPAN) connectivity in each Kontron M2M Smart Services Developer Kit.

17 Memory The M2M System in the Kontron M2M Smart Services Developer Kit board supports 1GB of DDR2 memory. For high volume M2M system prod

18 3 Component Installations This chapter covers installation of components included in the box and user added components that do not requ

19 Figure 13 shows both 802.11/802.15.4 antennas directed upward and the 3G antennas pointing outward. The 3G antennas do not bend. Figure

www.kontron.com www.kontron.com » Table of Contents « 1 Introduction ... 5 1.1 About this Manual ...

20 3.3 Installing the LiveUSB Drive The Kontron M2M Smart Services Developer Kit comes with a USB drive that provides software demos that

21 Begin to insert the SIM card in the SIM card slot on the top of the M2M System as shown in Figure 16. Figure 16. Beginning to insert SI

22 4 Operating Guide 4.1 Turning On the M2M System There is no on-off switch or button for the M2M System. To turn on follow these steps:

23 4.5 UEFI BIOS The M2M System uses a UEFI BIOS version 2.2 compliant with a boot loader. Some of the benefits of the Kontron M2M System

24 4.9 Changing the BIOS The Aptio Setup Utility changes system behavior by modifying the Firmware configuration. The setup program uses a

25 OS Support  BASE OS supporting standard On board hardware (details of the OS Ingredients to be added) Connectivity Drivers  On Board

26 WebIF can be reached via any browser (for example, Mozilla or Chrome) from any PC or workstation that has a LAN (via the Ethernet port)

27 5 Drop-In PCI Express Mini Card 3G Module Installation 5.1 3G- Enabled SKUs of the M2M System Selected SKUs come with a pre-certified

28 5.4 3G Installation Overview & Safety Information The following sections present general installation and removal procedures that a

29 Figure 20. Remove side screw Once the top and bottom chassis cover is unscrewed you can lift off the chassis cover including the top a

www.kontron.com www.kontron.com 4.3 Turning Off the M2M System ... 22 4.4 Indicator Lights

30 Figure 22. Remove AV card screw 5.7 Antenna Cable Routing At all times care must be taken not to alter the antenna cable routing. Al

31 5.8 Attaching and Installing the Module The white cord (antenna) from the top of the corner of the system must be attached to the 3G mo

32 The system includes a small circuit board spacer to position the AV board at the right height when no modem is installed. This spacer m

33 Next, screw down the 3G module using a torque screwdriver (torque spec. 1.5 inch/pound) and the screw just removed. Only one corner of t

34 Next, use the torque screwdriver to attach all 3 screws as shown in Figure 31. Figure 31. Holding the AV board in place. Using a t

35 5.10 Re-installing the Chassis Covers Follow this procedure (Using a torque screwdriver (torque spec. 1.5 inch/pound)) 1. Position the

36 6 Troubleshooting This chapter helps you identify and solve problems that might occur while you are using the Kontron M2M Smart Servic

37  Are all device drivers properly installed? This may be a problem if you have added a 3G module to the system that is not supported.

38  The onboard video for the M2M system is automatic or LVDS and also depends on single or dual monitors option.  Cards in the M2M Sys

39  Make sure the correct networking software is installed. If you have added a pre-certified module to the system other than the Ericsso

www.kontron.com www.kontron.com Characters are Distorted or Incorrect ... 38 Cannot Connect to a Kon

40 7 Warranty This Kontron product is warranted against defects in material and workmanship for 2 years from the date of shipment. During

41 Appendix A: Safety Information Warning: This product has been designed for service development purposes. Although this product has alre

42 Do not attempt to modify or use the supplied AC power cord if it is not the exact type required. There is no power button on the M2M

43 The M2M system in the development kit is designed to operate in a typical office environment. Choose a site that is: • Clean and free o

44 Appendix B: Regulatory and Certification Information B.1 Product Regulatory Compliance Product Safety Compliance The Carrier Grade Kon

45 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Ru

46 Radio Frequency Interference Radio-frequency emissions from electronic equipment can negatively affect the operation of other electroni

47 Appendix C: Getting Help C.1 World Wide Web Technicians and engineers from Kontron and/or its subsidiaries are available for technical s

48 Document Revision History Revision Publish Date Author Summary of updates 1.0 2011 Staff Initial release 1.04 2011 Staff Technical updat

49 Corporate Offices Europe, Middle East & Africa Oskar-von-Miller-Str. 1 85386 Eching/Munich Germany Tel.:

5 1 Introduction 1.1 About this Manual Thank you for purchasing and using the Kontron M2M Smart Services Developer Kit. This manual is fo

6 Chapter 7 Warranty The chapter provides the warranty information for the kit. Appendix A Safety Information The appendix provides the em

7 Figure 1 shows the Kontron M2M Smart Services Developer Kit Box Figure 1. Kontron M2M Smart Services Developer Kit Box 1.6 Additional

8 2 Product Description This chapter briefly describes the main features of the Kontron M2M Smart Services Developer Kit. It provides a di

9 Table 2 summarizes the major features of the Kontron M2M Smart Services Developer Kit system. Table 2. Kontron M2M Smart Services Devel