Kontron AT8902 Full Size CLI Instrukcja Użytkownika Pobierz pdf (Strona 202)

AT8901/2/3

AT8901/2/3 CLI Reference Manual Page 5 - 6

NOTE: Only one extension interface can exist on a AT8901

5.3.5.1 no atca port override

With the “no”-form the user specified marking is removed and the port is set to the e-

keying state (the “enable/disable” specification is not used, but must be specified)

Format

no atca port override {enable | disable} <I/F> <channel>

<port>

Mode Global Config

For I/F mapping see Table 5.1. “Interface mapping” on page 5 - 5

5.3.6 atca ekeying invalidate

This command forces the transfer of e-keying state of all ports to the hardware

Format

atca ekeying invalidate all

Mode Global Config

5.3.7 show atca ekeying

This command displays the current ekeying or user specified status for all ports

(channel/port) of all existing base or fabric interfaces. Currently no difference between

“brief” and “all” exists

Format

show atca ekeying {base | extension} {brief | all}

Mode Privileged EXEC

NOTE: The extension option is only available on a AT8902

5.4 System Information and Statistics Commands

This section describes the commands you use to view information about system

features, components, and configurations.

5.4.1 show arp switch

This command displays the contents of the IP stack’s Address Resolution Protocol

(ARP) table. The IP stack only learns ARP entries associated with the management

interfaces - network or service ports. ARP entries associated with routing interfaces are

not listed.

Format

show arp switch

Mode Privileged EXEC

IP Address IP address of the management interface or another device on the man-

agement network.

MAC Address Hardware MAC address of that device.

extension extension fabric interface PCIE/ASI 1-15 0

Table 5.1. Interface mapping

I/F Description Channel Port

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 303 304

Brak uwag

Kontron AT8902 Full Size CLI Instrukcja Użytkownika Strona 202